-we will not be running this class in 2006. special shows only-
IF THE RULES DON'T SAY YOU CAN DO IT...DON'T.
ALL CARS ARE SUBJECT TO OFFICIALS APPROVAL.
*BODY- AMERICAN OR FOREIGN MADE REAR WHEEL DRIVE, FRONT ENGINE, SEDAN, OR STATION WAGON. STATION WAGON MUST HAVE SIDE WINDOWS OUT. MOTOR & TRANSMISSION MUST REMAIN STOCK AND IN STOCK LOCATION. ENGINE MUST MATCH CAR (FORD TO FORD, GM TO GM, ETC.). NO PICKUPS!
*ENGINES- 4 CYLINDER SINGLE CAM ENGINE ONLY. STARTER AND CLUTCH MUST BE OPERATIONAL. HEADERS ALLOWED. 2500 CC MAXIMUM SIZE ENGINE. NO AFTERMARKET RACING HEADS ALLOWED. ALUMINUM HEADS ALLOWED ONLY ON ORIGINAL MAKES & MODELS OF CARS. PORTING OR POLISHING OK. 40 OVERBORE OK, BUT MUST NOT PUMP MORE THAN 2540 CC.
*CARBURETION- MAX 500 CFM, 2BBL -NO FUEL INJECTION. AFTERMARKET INTAKE ALLOWED. GAS ONLY.
*SUSPENSION- MUST REMAIN STOCK. WEIGHT JACKS ALLOWED. NON-ADJUSTABLE PULLBARS ALLOWED. NO TRACTION DEVICES OF ANY KIND.
*SHOCKS- 0NE SHOCK PER WHEEL. NO COILOVERS. RACING SHOCKS & SPRINGS ALLOWED. MUST BE IN STOCK LOCATION. NO ADJUSTABLE STRUTS ON FRONT.
*REAR ENDS- CAN BE LOCKED. MUST REMAIN IN STOCK LOCATION FOR CAR. (EIRI). PASSENGER CAR REAR ENDS ONLY. NO RATCHET REAR ENDS ALLOWED.
*BRAKES- ALL FOUR WHEELS MUST BE TOTALLY OPERATIONAL & STOCK. MUST HAVE STOCK MASTER CYLINDER AND PEDAL IN STOCK LOCATION.
*BODIES- ALL CARS MUST HAVE FULL FLOOR BOARDS AND FULL FIRE WALL. ALL HOLES MUST BE SEALED WITH ALUMINUM OR SHEET METAL. NO BARS WILL BE ALLOWED OUTSIDE THE CAR OR ON THE FRAME TO ACT AS NERFING BARS. ALL GLASS & MIRRORS MUST BE REMOVED. DOORS, HOOD, & DECK LID MUST BE SECURELY FASTENED & A SCREEN & BARS IN FRONT OF THE DRIVER.
*WHEELS- STEEL WHEELS ONLY, 8” MAXIMUM WIDTH.
*TIRES- ANY TIRES ALLOWED THAT FIT IN THE TIRE HOOP. GROOVING IS ALLOWED. 8”.
*SPOILERS- ANY TYPE. NO SIDE BOARDS. HEIGHT LIMIT OF 8”.
*FRAMES- MUST BE STOCK FOR MAKE & MODEL OF CAR & X'D OUTSIDE UNDERNEATH DRIVE SHAFT. TUBE FRAMES ARE ALLOWED.
*WEIGHT- MUST WEIGH 2200 LBS., WITH DRIVER, AFTER RACE.
*ROLL CAGES- A FULL PERIMETER FOUR POST ROLL CAGE WITH AN X-BRACE IN REAR & REAR KICKERS MUST BE USED. ROLL BAR PADDING RECOMMENDED IN DRIVERS COMPARTMENT. ROLL CAGE MUST BE SECURELY WELDED TO FRAME OR TO UNI-BODY. MUST HAVE MINIMUM OF ONE CROSS BAR IN TOP HALO OF ROLL CAGE. MINIMUM .095 TUBING AT LEAST 1.5 OUTSIDE DIAMETER FOR CAGE AND DOOR BARS. 3 HORIZONTAL DOOR BARS ON DRIVER'S SIDE ARE MANDATORY. MINIMUM OF 3 UPRIGHTS TIED FROM BOTTOM TO TOP DOOR BAR ON DRIVER SIDE. ABSOLUTELY NO SQUARE TUBING OR GALVANIZED PIPE ALLOWED. FUEL CELL PROTECTION BAR MAY BE USED, MOUNTED FRAME RAIL TO FRAME RAIL, NO HIGHER THAN THE FUEL CELL & INSIDE THE TRUNK AREA. MAXIMUM 1.75” PIPE.
*BUMPERS- STOCK TYPE, SQUARE, OR ROUND TUBING WITH ENDS CAPPED. WIDTH OF BUMPER NOT TO EXCEED PAST THE CENTER OF REAR TIRES UNLESS STOCK BUMPER IS USED.
*SAFETY- DRIVER MUST WEAR APPROVED SEAT BELTS & SHOULDER HARNESS. (3” X 5 POINT MUST BE INSTALLED WITH A MINIMUM OF 7/16” GRADE 5 BOLTS W/ LOCK NUTS.) ALL DRIVERS MUST WEAR A SFI APPROVED DRIVING SUIT (TOP & BOTTOM) AND SAFETY HELMET.
*SA-95 RATING HELMET RECOMMENDED. FIRE EXTINGUISHER REQUIRED AND MUST BE IN EASY REACH FOR THE DRIVER.
*SEAT- MUST HAVE APPROVED RACING SEAT. MUST BE MOUNTED WITH FENDER WASHERS AND A MINIMUM 4-3/8” GRADE 5 BOLTS. ALUMINUM SEAT RECOMMENDED.
*FUEL TANK- MUST BE OF HEAVY GAUGE MATERIAL & SECURELY MOUNTED OUT OF THE DRIVERS COMPARTMENT.
*FUEL PUMPS- IF ENGINE IS EQUIPPED FOR MECHANICAL PUMP IT MUST BE USED.
*ELECTRIC PUMPS- MUST HAVE OIL PRESSURE SHUT OFF.
*GASOLINE- GAS ONLY. NO ALCOHOL. NO ADDITIVES. RACING FUEL OKAY.
FOR MORE-INFORMATION:
VISIT WWW.LEBANONMIDWAYSPEEDWAY.COM OR CALL 417-588-4430- HAROLD ARMSTRONG.
MIDWAY SPEEDWAY IS LOCATED ON HWY. 32 EAST 5 MILES TO HWY. B. TURN RIGHT AND GO 1/2 MILE, LOCATED ON THE RIGHT.
